Genie

Genie install instructions here

The easiest way to get Genie going the to get your Lich Path and Ruby Path from Wrayth when you install Lich for the first time by running ;version as below:

Based on the screenshot above as an example, your Ruby Path would be our Ruby Location which is C:/Ruby4Lich5/3.3.1/bin/rubyw.exe

The 3.3.1 is the Ruby version included with Lich 5.9.2. Yours might vary.

Another way to find out the correct path is to navigate to C:\Ruby4Lich5 and look for the highest version you have listed. See screenshot:

In my example it is 3.3.1 so we set our Ruby Path to #config rubypath C:/Ruby4Lich5/3.3.1/bin/rubyw.exe

Based on the above ;version screenshot again, your Lich Path would be our Lich Location which is C:/Ruby4Lich5/Lich5/lich.rbw

In our example, the lich path is C:/Ruby4Lich5/Lich5/lich.rbw so we set our Lich Path to #config lichpath C:/Ruby4Lich5/Lich5/lich.rbw

Then we run #config save

At this point, if you have been very lucky... you should be able to #lc and everything should work as expect.

Additional details about using Lich with Genie in the Genie wiki