RFTools Builder
Using the Builder it is possible to copy, move, or swap areas in the world to other locations. It needs energy to do that and in case of the 'copy' mode it also needs an inventory on top or below it containing the blocks to build with.
Using the GUI you can control where the builder should place the blocks (always at the back of the builder).
Other GUI options are:
- Silent mode: mute sounds from moving blocks.
- Support mode: In this mode support blocks are created at the source and destination areas. This helps to see where the end result will go as well as support sand/gravel and liquids during the move.
- Entity mode: also move entities.
- Loop mode: In this mode the builder will keep running as long as it has a redstone signal and keep on moving or copying if there is room to do so. If this is off the builder will do one pass and stop.
You can use Space Chamber blocks to mark the corners of the source area that you want to work. One of these corners should be a Space Chamber Controller block.
Right selecting the controller block with a wrench will let it form the chamber. If all is correct you will get a message saying so. Then you need to use a Space Chamber Card (right click it on the controller) to link the controller to the card.
Then put that card in the builder, set the right mode and other parameters and give it a redstone signal.
If you right click a linked space chamber card it will give you an overview of all blocks and entities together with the cost of moving them.