Instructions for combining Lich with Genie & Frostbite FE

General Instructions

basic steps are as follows, you need a working lich install https://lichproject.org/download.html#win_storm_wiz_lich

Set up dependency in SF https://github.com/rpherbig/dr-scripts/wiki/First-Time-Setup steps 1-3

While connected through SF, run ;e toggle_lich_fork

that should take 5-10 seconds to swap the version of Lich you're on. Run that command again at any time to toggle back. Then you're basically done with SF. close out if it.

Genie-specific instructions

Get your genie client open

Open up an administrator command prompt (win+x then A in windows 8+) navigate to your lich directory and in the command prompt run

• 'ruby lich.rbw --dragonrealms --genie'

Then connect to a character via genie like normally.

You should have lich access, the only difference will be it uses , instead of ; as it's special character since Genie does parsing on ;

If you disconnect from that character (even keeping genie open) you'll need to run the command again in the command prompt.

Frostbite-specific Instructions

Download Frostbite from: http://matoom.github.io/frostbite/installation.html

Windows

Open up an administrator command prompt (win+x then A in windows 8+) navigate to your lich directory and in the command prompt run

• 'ruby lich.rbw --dragonrealms --frostbite'

Then connect to a character via genie like normally.

Mac OS X / *nix

Open up command prompt Navigate to your lich directory:

• ex. 'cd ~/Downloads/lich'

Run Lich.rbw with the following options

• 'sudo ./lich.rbw --dragonrealms --frostbite'

Then connect to a character via Frostbite like normally.