floor-heating-controller

esphome firmware for esp32_8ch_motor_shield

#install esphome

pip install --upgrade esphome

#Preparation

• Check the wiki
• Adapt config.yaml to your needs
• Adapt sensor_temperature.yaml with your temperature sensors
• Adapt wifi.yaml + secrets.yaml

#1st time upload :

• Detach the ESP32 board from the shield and connect it the through usb
• for flashing : press boot button for 2-3 seconds before the serial connection initialize
• After OTA update, the EN (reset) button must be pressed to run firmware
• do not use gpio12 (MTDI)
• the future binary upload will go trough OTA wireless

#compile to check for errors

esphome compile config.yaml

#compile & upload

esphome run config.yaml