OctoPrint provides a responsive web interface for controlling a 3D printer (RepRap, Ultimaker, ...). It is Free Software and released under the GNU Affero General Public License V3.
Its website can be found at octoprint.org.
Please see the project's Contribution Guidelines.
Installation instructions for installing from source for different operating systems can be found on the wiki.
If you want to run OctoPrint on a Raspberry Pi you might want to take a look at OctoPi which is a custom SD card image that includes OctoPrint plus dependencies.
OctoPrint depends on a couple of python modules to do its job. Those are automatically installed when installing
OctoPrint via setup.py:
python setup.py install
You should also do this every time after pulling from the repository, since the dependencies might have changed.
OctoPrint currently only supports Python 2.7.
Running the setup.py script installs the octoprint script in your Python installation's scripts folder
(which depending on whether you installed OctoPrint globally or into a virtual env will be on your PATH or not). The
following usage examples assume that said octoprint script is on your PATH.
You can start the server via
octoprint
By default it binds to all interfaces on port 5000 (so pointing your browser to http://127.0.0.1:5000
will do the trick). If you want to change that, use the additional command line parameters host and port,
which accept the host ip to bind to and the numeric port number respectively. If for example you want the server
to only listen on the local interface on port 8080, the command line would be
octoprint --host=127.0.0.1 --port=8080
Alternatively, the host and port on which to bind can be defined via the configuration.
If you want to run OctoPrint as a daemon (only supported on Linux), use
octoprint --daemon {start|stop|restart} [--pid PIDFILE]
If you do not supply a custom pidfile location via --pid PIDFILE, it will be created at /tmp/octoprint.pid.
You can also specify the configfile or the base directory (for basing off the uploads, timelapse and logs folders),
e.g.:
octoprint --config /path/to/another/config.yaml --basedir /path/to/my/basedir
See octoprint --help for further information.
OctoPrint also ships with a run script in its source directory. You can also invoke that to start up the server, it
takes the same command line arguments as the octoprint script.
If not specified via the commandline, the configfile config.yaml for OctoPrint is expected in the settings folder,
which is located at ~/.octoprint on Linux, at %APPDATA%/OctoPrint on Windows and
at ~/Library/Application Support/OctoPrint on MacOS.
A comprehensive overview of all available configuration settings can be found on the wiki. Please note that the most commonly used configuration settings can also easily be edited from OctoPrint's settings dialog.