Skip to content

jow-/udp-balancer

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

2 Commits
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

udp-balancer

The udp-balancer service is a tiny, standalone round-robin balancer for arbitrary UDP packets.

The main use case is to split up incoming UDP traffic into evenly sized flows which are distributed among defined upstream destinations.

Since this program was written to allow for distributed log shipping, it also supports handling of chunked GELF messages to ensure that all fragments of a multi chunk message are sent to the same upstream.

Installation

Simply clone this repository and perform a make install to compile the udp-balancer binary and install it into the filesystem.

You may override the DESTDIR variable to specify an alternative to the default /usr/local prefix or invoke make udp-balancer to only compile, but not install the program.

$ make install
$ make install DESTDIR=/usr
$ make udp-balancer

Configuration

By default, the udp-balancer executable attempts to open the configuration at /etc/udp-balancer.conf, an alternative location can be specified as first argument.

$ udp-balancer
$ udp-balancer ./alternative-config.conf

The configuration file consists of a series of statements, mainly a single listen directive and one or more upstream declarations. Additional options are handle-gelf, send-buffer and recv-buffer.

An example configuration may look like:

handle-gelf
send-buffer 0x10000000
recv-buffer 0x10000000

listen 0.0.0.0:12201
upstream 1.1.1.1:12201
upstream 2.2.2.2:12201
upstream 3.3.3.3:12201

This configuration will instruct udp-balancer to bind a listening socket to port 12201 on all local interfaces and to distribute incoming UDP packets to the hosts 1.1.1.1, 2.2.2.2 and 3.3.3.3 on port 12201 respectively.

Additionally support for chunked GELF messages is enabled and the send- receive buffers of the socket are set to 256MB each.

Limitations

The udp-balancer program does not attempt to implement the complete GELF specification, it merely checks if the first two bytes of a message match the magic bytes 0x1f 0x0f.

If a GELF chunk message is identified, udp-balancer will calculate a CRC8 hash of the message ID at bytes 3..10 and perform a module operation over it to choose an upstream.

As the GELF specification requires all chunks of a message to carry the same ID, all chunks will be sent to the same upstream, leaving it to the remote listener to properly reassemble (or discard) messages.

About

Tiny and simple UDP balancer

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published