========================================================= Pre-reqs:

Wifi connected

SD Card with latest Weezy OS installed

Raspberry Pi Camera

SSH setup

========================================================= Step 1 - Make sure your Raspberry Pi is up to date:

sudo apt-get install rpi-update

sudo rpi-update

========================================================= Step 2 - Make sure all your packages are up to date:

sudo apt-get update

sudo apt-get upgrade

========================================================= Step 3 - Disable the cameras LED:

sudo nano /boot/config.txt

disable_camera_led=1

========================================================= Step 4 - Install motion detection software:

sudo apt-get install motion

cd /tmp

sudo apt-get install -y libjpeg62 libjpeg62-dev libavformat53 libavformat-dev libavcodec53 libavcodec-dev libavutil51 libavutil-dev libc6-dev zlib1g-dev libmysqlclient18 libmysqlclient-dev libpq5 libpq-dev

wget https://www.dropbox.com/s/xdfcxm5hu71s97d/motion-mmal.tar.gz

tar zxvf motion-mmal.tar.gz

sudo mv motion /usr/bin/motion

sudo mv motion-mmalcam.conf /etc/motion.conf

sudo nano /etc/default/motion

start_motion_daemon=yes

sudo chmod 664 /etc/motion.conf

sudo chmod 755 /usr/bin/motion

sudo touch /tmp/motion.log

sudo chmod 775 /tmp/motion.log

sudo nano /etc/motion.conf

daemon on logfile /tmp/motion.log width 1280 height 720 framerate 2 pre_capture 2 post_capture 2 max_mpeg_time 600 ffmpeg_video_codec msmpeg4 stream_localhost off stream_auth_method 2
stream_authentication SOMEUSERNAME:SOMEPASSWORD

sudo reboot

========================================================= Step 5 - Fix motion autostart:

sudo nano /etc/init.d/motion

Before the line "log_daemon_msg "Starting...." add the following line

sleep 30