This is intended to implement a simple command-line LLRP configuration tool for setting IP addresses and such for Miranda devices. It should also be useful for other LLRP devices.
LLRP is a part of ANSI E1.33, this is based off the standard dated 9/02/2019.
Not really built out yet.
- DISCOVERY
- DEVICE_LABEL (get/set)
- FACTORY_DEFAULTS
- IDENTIFY_DEVICE on/off
- RESET_DEVICE
- IPV4_DHCP_MODE
- IPV4_CURRENT_ADDRESS
- IPV4_STATIC_ADDRESS
- IPV4_DEFAULT_ROUTE
li : list computer IP interfaces si : select computer IP interface d : run discovery l # [label] : get/set device label (don't specify a label to just get) factory # : reset to factory defaults i # [on/off] : get identify status, or turn on/off reset # : reset device dhcp # [on/off] : get dhcp status, or turn on/off c # : get current IP address setip # [dotted quad] [netmask] : get static IP address, or set it gw # [dotted quad] : set gateway address p : print device table r : refresh device table (re-runs discovery, then gets parameters and prints the table)