CemuShake

Linux and Windows app to simulate a shake motion input with a standard controller using the cemuhook protocol.

Anything that uses the cemuhook (dsu) protocol should be compatible with this, if it lets you map a standard controller alongside this.

The main purpose for the development for this tool was to do motion exclusive throws in Mario Odyssey (Ryujinx).

Usage

Configure your client (Ryujinx, Dolphin, etc...) like any other dsu client, with your ip and port 26760, or set up a custom port in the config file.
Turn on controller, open CemuShake and open your client. It should work.

By default RB (R1) is a shake with no gyro, to change this see the configuration section below.

Configuration

You can configure the actions and some stuff creating a yaml config file in your home folder. It should be in $HOME/.config/CemuShake.yml

Valid configs are:

Key	Value	Description
port	uint	Network port to use for the server
buttons	list	List of actions with its correspending button, see table below to see how to add an entry

Buttons list elements:

Key	Value	Description
id	uint	Controller button to map, see below for possible values
accX	float	Accelerometer value in X
accY	float	Accelerometer value in Y
accZ	float	Accelerometer value in Z
pitch	float	Value to apply to pitch over time
yaw	float	Value to apply to yaw over time
roll	float	Value to apply to roll over time

Buttons id values:

Id	Button (Xbox notation)	Button (PS notation)
0	A	X
1	B	O
2	X	□
3	Y	△
4	Back	Share
5	Guide	PS
6	Start	Options
7	LStick	L3
8	RStick	R3
9	LB	L1
10	RB	R1
11	Up	Up
13	Down	Down
12	Left	Left
14	Right	Right
15	Share	Mic (PS5)
16	Paddle 1 (Elite)	Not applicable
17	Paddle 2 (Elite)	Not applicable
18	Paddle 3 (Elite)	Not applicable
19	Paddle 4 (Elite)	Not applicable
20	Not applicable	Touchpad

Example config file

---
port: 26760
buttons:
    - id: 9 # LB
      accX: 0
      accY: 200 # Shake Up
      accZ: 0
      pitch: -20 # Gyro backwards
      yaw: 0
      roll: 0
    - id: 10 # RB
      accX: 0
      accY: 200 # Shake up
      accZ: 0
      pitch: 20 # Gyro forward
      yaw: 0
      roll: 0

Building

You need SDL2 for the controller and yaml-cpp for the config, so install those through your package manager or with vcpkg as described in the dependencies section.

On linux you just need to run make
On Windows for now you need to set up a VS project, import the files and compile.

Dependencies

For ubuntu:
sudo apt-get install libsdl2-dev libyaml-cpp-dev

For Fedora:
sudo dnf install SDL2-devel yaml-cpp-devel

For Windows (vcpkg):
vcpkg install sdl2 yaml-cpp

Acknowledgements

Valeri for his documentation Cemuhook-Protocol
kmicki for his SteamDeckGyroDSU wich i borrowed a lot of the server code