Tamarin C Case

3D printable case for the Tamarin C.

More pictures can be found here.

Instructions / Recommendations

This case was tested with PLA on a Prusa i3 MK2S.

Assembly

To assemble the case, place the PCB into the bottom half. It helps to position the USB Micro end first and then gently press down the opposite side. Finally, close the case with the lid. The PCB should not need to be forced into place—it will fit easily if aligned correctly.

To-Do

• Fix lid wiggle
• Adjust slot for the pin header (currently off by ~1mm)

License

This hardware is licensed under the CERN-OHL-W-2.0 - CERN Open Hardware License.

Thanks

Thanks to Stacksmashing for providing free Tamarin C boards at 37C3, making it possible for me to design this case.