Balancing automaticliy switches ON

[peff74]

I have a question about balancing.
For some reason, I do not know, the balancing switches on again and again.
So, when I set the switch to OFF it is ON again the next day.

I could swear to have seen somewhere a place in the script where you could specify a voltage range in which the balancing is switched on, but I can't find it again for the life of me :-(

Am I wrong, or am I just blind?

Thanx for helping me out

[peff74]

after now a few days of closer observation, it turns out the following. If Switch/jk-bms_balancer/command in the MQTT in the ioBroker has the value OFF or ON, this is set sooner or later in the BMS.
Can it be that the software does not run stably?
Or is the ESP restarted regularly?

Then the value is probably taken over during a restart and set in the BMS.