How to switch on/off charging/discharging in iobroker?

[rolandm1234]

I have flashed a esp32 with ble firmware, connected via mqtt to iobroker and get all sensors in iobroker.
i have the datapoints jbd-bms-ble/switch/jbd-bms-discharging/command and state but cannot switch discharging on/off.

what is the syntax?

[syssi]

Controls aren't implemented yet. I did add the switch entities already but the don't issue any commands to the BMS yet.

[syssi]

Please track the progress of the merge request: #36

As soon it's merged you can control the switches using the command topic with the payload ON and OFF.

[syssi]

If you change this substitution from:

substitutions:
  external_components_source: github://syssi/esphome-jbd-bms@main

to

substitutions:
  external_components_source: github://syssi/esphome-jbd-bms@add-controls

and flash your ESP again you could test the mosfet switches already!

[rolandm1234]

roland@ro02:~/esphome-jbd-bms$ esphome run esp32-ble-example.yaml 
INFO Reading configuration esp32-ble-example.yaml...
INFO Updating https://github.com/syssi/esphome-jbd-bms.git@add-controls
Failed config

switch.jbd_bms_ble: [source esp32-ble-example.yaml:211]
  platform: jbd_bms_ble
  jbd_bms_ble_id: bms0
  charging: 
    name: jbd-bms-ble charging
  discharging: 
    name: jbd-bms-ble discharging
  
  [balancer] is an invalid option for [switch.jbd_bms_ble]. Please check the indentation.
  balancer: 
    name: jbd-bms-ble balancer

[syssi]

Please remove the balancer switch from your YAML temporary.

[rolandm1234]

ok, switching charging/discharging is working now.