Skip to content

Latest commit

 

History

History
62 lines (44 loc) · 3.37 KB

README.md

File metadata and controls

62 lines (44 loc) · 3.37 KB
Raw

Antenna Rule Checker

This tool checks antenna violations of a design in OpenDB, and generates a report to indicate violated nets. APIs are provided to help fix antenna violations during the diode insertion flow in global route.

Antenna Report Example

This is an example of the detailed and simple reports of the antenna checker:

:alt: Antenna checker report
:class: bg-primary
:width: 500px
:align: center

Abbreviations Index:

  • PAR: Partial Area Ratio
  • CAR: Cumulative Area Ratio
  • Area: Gate Area
  • S. Area: Side Diffusion Area
  • C. Area: Cumulative Gate Area
  • C. S. Area: Cumulative Side (Diffusion) Area
Antenna Checker Algorithm: WireGraph Example Step 1: (a) Start from the root node (ITerm) using upper Via to find a node for a new wire. (b) Save the ITerm area for cumulative gate/diffusion area.
Step 2: From the node of the wire, find all the nodes in the wire through segment wires and find the "root" node of this wire. Step 3: (a) From the "root" node of the wire, along the outgoing segment edge that goes to other nodes belonging to this wire, calculate the area of this wire. (b) Then, find all the ITerms below these nodes, except for the root node (directly use an ITerm or lower Vias to find ITerms for lower metals). (c) Sum up the areas of all the ITerms found with the cumulative areas and calculate the PAR of this wire. (d) Add the PAR value and the wire info (layer, Index) into the PAR table. Add the new area to the cumulative areas.
Step 4: Find all the upper Vias on this wire (for all the nodes on this wire), and go to the higher-level metal. Step 5: Repeat Steps 2 and 3 for new-found upper-level wires.
Step 6: Repeat Steps 4 and 5 until we reach a wire that cannot have upper Vias for its nodes (highest-level metal). Step 7: Pick up another ITerm as a root node and repeat Steps 1 to 6, skipping the wires already in the PAR table. Repeat this for all the ITerms to get a whole PAR table.
Step 8: (a) Pick up a gate ITerm and a node of a wire (e.g., M4,1). Find possible paths that connect them, look up the PAR value of the wires along these paths, and add them up to get the CAR of the (gate, wire) pair. (b) Compare to the AntennaRule to see if the CAR violates the rules. (c) Check this for all (gate, wire) pairs.

Commands

check_antennas

Check antenna violations on all nets and generate a report.

check_antennas [-report_filename <FILE>] [-report_violating_nets]
  • -report_filename: specifies the filename path where the antenna violation report is to be saved.
  • -report_violating_nets: provides a summary of the violated nets.

Limitations

FAQs

Check out GitHub discussion about this tool.

License

BSD 3-Clause License. See LICENSE file.