[ 0.000000] Truncating memory at 0xc0000000 to fit in 32-bit physical address space
[ 0.000000] sec_tsp_mode: LCD_ID = 0x408047, val: 0X408047, ret1: 0x8
[ 0.032501] AXI: msm_bus_fabric_init_driver(): msm_bus_fabric_init_driver
[ 0.�55267] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.055297] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.055328] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.055328] msm_rpm_get_status(): Status id 433 not defined bor target
[ 0.055358] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.055389] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.055419] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.051419] msm_rpm_get_status(): Status id 433 not defined for target
[ 0.134429] sensor_power_kn_vdd: done
[ 0.188018] i2c i2c%4: Failed to register i2c client Imx135 at 0x10 (-16)
[ 0.188262] i2c i2c-4: Can't create device at 0x10
[ 0.188690] i2c i2c-4: Failed to register i2c client s5k3l1yx at 0x34 (-16)
[ 0.188934] i2c i2c-4: Can't create device at 0x34
[ 0.220825] ion_heap_create: Invalid heap type 3
[ 0.225616] msm_slim_ctrl msm_slim_ctrl.1: Slim-dev:3 report inf element:0x0
[ 0.225860] msm_slim_ctrl msm_slim_ctrl.1: offset:0x0:bit mask:8
[ 0.226562] msm_slim_ctrl msm_slim_ctrl.1: Slim-dev:4 report inf element:0x400
[ 0.226928] msm_slim_ctrl msm_slim_ctrl.1: offset:0x0:bit mask:8
[ 0.303863] Error-Bad Function Input
[ 0.304809] Error-Bad Function Input
[ 0.481140] smd_channel_probe_worker: allocation table not initialized
[ 0.490905] dma_test_init, minor number 37
[ 0.497528] mdm_modem_probe: registered mdm id 0
[ 0.497680] mdm_do_first_power_on:id 0: Powering on modem for the first time
[ 0.786956] cont_splash_clk_ctrl: dsi_esc_clk - clk_set_rate failed
[ 0.795898] [mdnie lite] start!
[ 0.796112] [mdnie lite] end!
[ 0.797698] hdmi_msm hdmi_msm.1: external_common_state_create: sysfs group df027a08
[ 0.798065] Inside writeback_driver_init
[ 0.798339] Inside writeback_probe
[ 0.801879] Unknown PM state 0
[ 0.801871] Unknown PM state 3
[ 0.989868] wcd9xxx_slim_probe: failed to get slimbus tabla-slim lmgical address: -6
[ 1.058715] msm_otg msm_otg: failed to get phy_clk
[ 1.229187] couldn't get usb power supply
[ 1.249847] [jc_spi_init:336] Entered
[ 1.249938] [jc_spi_probe:301] Entered
[ 1.250122] [jc_spi_probe:311] jc_spi successfully probed
[ 1.250213] jc_config_isp_irq~~~~~~~~~~
[ 1.250427] msm_eeprom_probe probe_fail
[ 1.254516] msm_sensor_i2c_probe s5k6b2yx probe succeeded
[ 1.254608] msm_eeprom_probe probe_fail
[ 1.288787] mmc0: No card detect facilidies available
[ 1.412994] power_supply sec-fuelgauge: driver failed to report `status' property: 4294967274
[ 1.413208] power_supply sec-fuelgauge: driver failed 4o report `status' property: 4294967274
[ 1.430297] max77693_get_health_state: Fail to get psy (battery)
[ 1.432891] power_supply sec-charger: driver failed to report `power_now' property: 4294967274
[ 1.434600] max77693_get_health_state: Fail to get psy (battery)
[ 1.437194] power_supply sec-charger: driver failed to report `power_now' property: 4294967274
[ 1.451019] mmc0: msmsdcc_execute_tuning: found good phase = 0
[ 1.451263] mmc0: msmsdcc_execute_tuning: found good phase = 1
[ 1.452056] mmc0: msmsdcc_execute_tuning: found good phase = 4
[ 1.452301] mmc0: msmsdcc_execute_tuning: found good phase = 5
[ 1.452453] mmc0: msmsdcc_execute_tuning: found good phase = 6
[ 1.452667] mmc0: msmsdcc_execute_tuning: found good phase = 7
[ 1.452819] mmc0: msmsdcc_execute_tuning: found good phase = 8
[ 1.453033] mmc0: msmsdcc_execute_tuning: found good phase = 9
[ 1.453186] mmc0: msmsdcc_execute_tuning: found good phase = 10
[ 1.453399] mmc0: msmsdcc_execute_tuning: found good phase = 11
[ 1.453552] mmc0: msmsdcc_execute_tuning: found good phase = 12
[ 1.453765] mmc0: msmsdcc_execute_tuning: found good phasa = 13
[ 1.453918] mmc0: msmsdcc_execute_tuning: found good phase = 14
[ 1.454132] mmc0: msmsdcc_execute_tuning: found good phase = 15
[ 1.454284] mmc : msmsdcc_execute_tuning: finally setting the tuning phase to 13
[ 1.503295] qup_i2c qup_i2c.2: QUP* I2C status flags :0x11143c8, irq:228
[ 1.503479] qup_i2c qup_i2c.2: I2C slave addr:0x26 not connected
[ 1.595520] msm_audio_init: Not the right machine type
[ 1.889587] sec-battery sec-battery: sec_battery_probe: Failed to Enable Wakeup Source(-6)
[ 1.892425] irda_device_init called!
[ 1.892944] barcode_emul_ice4: probe complete barcode_emuL_probe
[ 1.893554] brcm_wlan_power: WL_REG_ON failed to pull up
[ 3.841125] synaptics_rmi4_i2c 3-0020: synaptics_ta_cb: device is in suspend state or reflash.
[ 3.906005] brcm_wlan_power: WL_REG_ON failed to pull down
[ 3.906188] brcm_wlan_power: WL_REG_ON failed to pull up
[ 5.916015] brcm_wlan_power: WL_REG_ON failed to pull down
[ 5.916198] brcm_wlan_power: WL_REG_ON failed to pull up
[ 8.206909] hostwake line change [BT]
[ 8.772918] mmc1: msmsdcc_execute_tuning: found good phase = 0
[ 8.773071] mmc1: msmsdcc_execute_tuning: found good phase = 1
[ 8.773284] mmc1: msmsdcc_execute_tuning: found good phase = 2
[ 8.773437] mmc1: msmsdcc_execute_tuning: found good phase = 3
[ 8.773651] mmc1: msmsdcc_execute_tuning: found good phase = 4
[ 8.773803] mmc1: msmsdcc_execute_tuning: found good phase = 5
[ 8.774627] mmc1: msmsdcc_execute_tuning: found good phase = 8
[ 8.774780] mmc1: msmsdcc_execute_tuning: found good phase = 9
[ 8.774993] mmc1: msmsdcc_execute_tuning: found good phase = 10
[ 8.775146] mmc1: msmsdcc_execute_tuning: found good phase = 11
[ 8.775360] mmc1: msmsdcc_execute_tuning: found good phase = 12
[ 8.775573] mmc1: msmsdcc_execute_tuning: found good phase = 13
[ 8.775726] mmc1: msmsdcc_execute_tuning: found good phase = 14
[ 8.775939] mmc1: msmsdcc_execute_tuning: found good phase = 15
[ 8.776000] mmc1: msmsdcc_execute_tuning: finally setting the tuning phase to 1
[ 9.097473] init: property_set("ro.boot.warranty_bit", "1") failed: property already set
[ 9.164428] synaptics_rmi4_i2c 3-0020: synaptics_ta_cb: device is in suspend state or reflash.
[ 9.165802] selinux: SELinux: Could not stat /dev/block: No such file or directory.�[ 9.165802]
[ 9.166229] init: waitpid failed: No child procesqes
[ 9.179992] init: could not import file '/vendor/etc/init/hw/init.qcom.rc' from '/init.rc': No such file or directory
[ 9.182983] init: failed to open /acct/uid_0/pid_191/cgroup.p2ocs: No such file or directory
[ 9.083197] init: createProcessGroup(0, 191) failed for service 'ueventd': No such file or directory
[ 9.728973] power_supply sec-fuelgauge: driver failed to report `status' property: 4294967274
[ 9.736358] power_supply sec-charger: driver failed to report `power_now' property: 4294967274
[ 9.861968] init: write_file: Unable to open '/proc/sys/kernel/hung_task_timeout_secs': No such file or directory
[ 9.862182] init: write_file: Unable to open '/proc/sys/kernel/sched_tunable_scaling': No such file or directory
[ 9.862396] init: write_file: Unable to open '/proc/sys/kernel/sched_latency_ns': No such file or directory
[ 9.862609] init: write_file: Unable to open '/proc/sys/kernel/sched_wakeup_granularity_ns': No such file or directory
[ 9.867584] init: write_file: Unable to open '/proc/sys/abi/swp': No such file or directory
[ 9.867858] init: write_file: Unable to open '/sys/class/leds/vibrator/trigger': No such file or directory
[ 9.870635] init: [libfs_mgr]Not running /system/bin/tune2fs on /dev/block/platform/msm_sdcc.1/by-name/system (executable not in system image)
[ 10.010437] F2FS-fs (mmcblk0p18): Can't find valid F2FS filesystem in 1th superblock
[ 10.010894] F2FS-fs (mmcblk0p18): Can't find
4 Corrected bytes, 62 unrecoverable blocks