Repeated errors?

[Weaselll]

I seem to repeatedly get both errors 31 and 995, even with redoing all the guide's steps. Would that be a problem on my end or are others getting this?

[natinusala]

Are you on Windows ? Error 31 is normal then - I don't know what error 995 is. On Windows I personnally have a 95% success rate.

Could you give me the full logs ?

[Weaselll]

Put your Switch in RCM mode now
TegraRcmSmash (64bit) 1.1.0-1 by rajkosto
Opened USB device path \?\usb#vid_0955&pid_7321#5&1cbdcd65&0&3#{8618666a-1afa-4a7f-873d-6765dcf82cf3}
RCM Device with id 4082FC0F00000008C4122E6401101062 initialized successfully!
Uploading payload (mezzo size: 0, user size: 2364, total size: 29904, total padded size: 32768)...
Switched to high buffer
Smashing the stack!
Smashed the stack with a 0x7000 byte SETUP request!
Switching to sending of section 'CBFS'
Sending 0x00007000 bytes from offset 0x00000000
Sending 0x00000004 bytes from offset 0x000ffffc
Sending 0x00000020 bytes from offset 0x00020138
Sending 0x00000018 bytes from offset 0x00020100
Sending 0x00000020 bytes from offset 0x00020118
Sending 0x00000018 bytes from offset 0x00020180
Sending 0x00000020 bytes from offset 0x00020198
Sending 0x0000001c bytes from offset 0x000201b8
Sending 0x00005332 bytes from offset 0x000201d4
Sending 0x00100000 bytes from offset 0x00000000
Finished sending section 'CBFS' (total bytes sent: 1098722)
Win32 error 995 during post-smash read op
Done
Press any key to continue . . .

[Weaselll]

And yes I am on Windows.

[natinusala]

Post-smash errors are normal - Linux should boot shortly after the CBFS section has been sent regardless of what happens next.

[Weaselll]

Linux boots SOMETIMES then goes to a black screen and stays.

[natinusala]

Is it a RCM black screen or just a black screen ?

[Weaselll]

Just a black screen.

[natinusala]

I'd say it comes from your SD card, try with another one if you can

[Weaselll]

Alright ill get back to you on that

[Weaselll]

Still getting the same errors, even after changing sd cards.

[Weaselll]

Update: tried with another switch and im getting consistent boot screens before going straight to black

[natinusala]

Without UART I'm afraid we won't be able to diagnose what's going on here