support LNB unicable

[Javito68]

Hello The lars,

I know that this is not the correct way to ask you a question that has nothing to do with this thread, in Github I am not able to find your email account so forgive me for using this contact method.
Question: I know that about 3 years ago you were with the unicable lnb's in the thread: perexg/satip-axe#99 the case is that I want to install two unicable lnb's of 4 receivers (one for each antenna with a combiner and a single cable to my Digibit R1 receiver with perexg / satip-ax, now it is working with a unicable lnb: OK), I know that for this to work you have to assign different SCR frequencies in each LNB, there is some feasible and inexpensive way (without buying the programmer) to do this? any other possible method?
and sorry. Thank you and best regards!

[email protected]

[lars18th]

Hi @Javito68 ,

Don't worry, this is a good method to contact! 😉

Regarding the Unicable LNB, you have this option of a low cost programer: https://github.com/akosinov/unicable
With this, you can reconfigure one LNB to be SRC=2 (B), and then you can connect both to the same wire and work with Unicable compatible devices.

I hope this helps you.
Regards.

[Javito68]

Hi The Lars, thanks for the reply, Did you get to try: https://github.com/akosinov/unicable ?, with which LNB ?, I want to test it with: unicable-ii-programmable-40mm-lnb-with-32-ub although I only need 4 user bands. I have a 4 tuner R1 digibit with firmware: satip-ax-201810211549 with a 4 SCR uniselect lnb with minisatip8: MINISATIP8_OPTS = "- diseqc-timing *: 155-54-15-15-15-0 -u 0: 0-1210,1: 1-1420,2: 2-1680,3: 3-2040" -> works OK, how should I configure the minisatip8 opts for the second LNB? Thanks and best regards!

…

________________________________ De: Lars The <[email protected]> Enviado: martes, 10 de noviembre de 2020 11:15 Para: lars18th/satip-rtp <[email protected]> Cc: Javito68 <[email protected]>; Mention <[email protected]> Asunto: Re: [lars18th/satip-rtp] support LNB unicable (#5) Hi @Javito68<https://github.com/Javito68> , Don't worry, this is a good method to contact! 😉 Regarding the Unicable LNB, you have this option of a low cost programer: https://github.com/akosinov/unicable With this, you can reconfigure one LNB to be SRC=2 (B), and then you can connect both to the same wire and work with Unicable compatible devices. I hope this helps you. Regards. — You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub<#5 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/ALBH7WIMTVQTN3TTR6RR3U3SPEHCNANCNFSM4TPQAMMA>.