Parameters are not taken over

[nuki47]

My settings in Digit ROI and Analog ROI are not transferred to the Overview view

I tried release v15.7.0 and 15.6.0
SD Card size: 29584 MB Toshiba/Kingston/Viking (ID: 2)

[0d00h00m05s] 2024-05-01T12:25:22 [WIFI] Manual interface config -> DNS: 192.168.100.2
[0d00h00m05s] 2024-05-01T12:25:22 [WIFI] Set hostname to: watermeter
[0d00h00m05s] 2024-05-01T12:25:22 [WIFI] Init successful
[0d00h00m10s] 2024-05-01T12:25:27 [WIFI] Connected to: xxxxxx, RSSI: -72
[0d00h00m10s] 2024-05-01T12:25:27 [WIFI] Assigned IP: 192.168.100.109
[0d00h00m25s] 2024-05-01T12:25:42 [MAIN] Device info: CPU cores: 2, Chip revision: 301
[0d00h00m25s] 2024-05-01T12:25:42 [MAIN] SD card info: Name: SA32G, Capacity: 29584MB, Free: 22MB
[0d00h00m27s] 2024-05-01T12:25:44 [MAIN] Initialization completed successfully
[0d00h00m30s] 2024-05-01T12:25:46 [LOGFILE] Set log level to ERROR

[caco3]

Not sure what you exactly mean.

Can you describe a bit more what you did?

And did you make sure to press the "save" buttons on every config page?

[nuki47]

Settings > Alignment > Reference Image and Camera Settings
Create New Reference / Change Camera Settings
Adjust some parameters (Rotation angle..)
Update Reference Image
Save new Reference Image and Camera Settings

Settings > Regions of Interest > Digital ROI
Adjust some parameters
save config

System > Reboot
Reboot
Rebooting!

Overview
Digital ROI are wrong

[SybexX]

If you change the reference image you must to redefine alignment marks, digital and analog ROIs, because everything refers to the reference image

[caco3]

save config

this step is needed on every page!

also note @SybexX's comments!

[nuki47]

ok, thanks...just one question. Why is the button "reset and show current reference and camera settings" inactive if I want change some parameters in the existing reference image?

[SybexX]

Since almost settings are handled by the camera, a new picture must be taken if you want to change the settings.
And when you open the page, the current reference image is loaded, so you can't reset any changes.

[nuki47]

If I would change some parameter for digit ROI (x/y parameters) and I clicke save config and do a reboot, the changes will not taken over....what's wrong in my doing?

[caco3]

what does the log say?
maybe there is an issue with your sd card?

[nuki47]

what's this, is this normal?
SD card info: Name: SA32G, Capacity: 29584MB, Free: 22MB

[caco3]

did you fill all 29 GB? How did you do this?
And what does the leg say?