Rate to high error - but i will get some Data

[tuvok81]

Hello Guys,
iam very new in this things.. and my english is bad! :) I have a Problem with the ESP32-CAM and your Software
i get data but i have no idea about the error

[haverland]

Set the previous value manually. By default a check (MaxRateValue) is enabled. So worse reading ends in error. The 42 is in my opinion the start value after setup. The previous value will also unset after a timeout (720minutes by default).

[tuvok81]

OK and what do i make in MaxRateValue for a entry?

[caco3]

just set the current value as previous Value under Settings > Set Precious Value

[tuvok81]

OK and what for a value do i add on this section?

[caco3]

the current raw value

[tuvok81]

ok i will show thx