parts_list

Printed parts

All parts can be printed on any decent 3D printer with sufficient build volume 
- for 4x5" a smaller printer with about 190x190x100mm build volume is sufficient
- for 5x7" a build volume of at least 235x235x100mm is required
- for 8x10" a build volume of at least 300x300x120mm is required

Print settings vary slightly for the different parts - if not explicitly mentioned use
- 0.2mm layers or better
- 4 walls
- 4 bottom/top layers
- when printing with PETG, use at least 15-20% more infill as hinted below, below numbers are for PLA
The tolerances between the parts are quite tight, so you have to sand them. I recommend sanding the dovetail parts with 400 wet sanding paper. 

printed parts list
- body, infill 30%, support for overhang angles over 60 degrees, support touching the build plate
- front lid, infill 30%, no supports
- front lid dovetail, infill 30%, no supports
- focusing block, infill 100%, no supports
- focusing wheel, infill 100%, no supports
- back plate, 30% infill, no supports
- locking rails (1x original, 1x mirrored), infill 100%, no supports
- locking levers (1x original, 1x mirrored), infill 100%, no supports
- rails, min 40% infill, support for overhang angles over 60 degrees
- slider, min 50% infill, no supports
- front standard, min 50% infill, support for overhang angles over 80 degrees, support everywhere
- front standard tilt plates (2x) min 50% infill, support for overhang angles over 80 degrees, support touching the build plate
- pulling lever plate, 100% infill, no supports
- pulling levers (1x original, 1x mirrored), 100% infill, no supports
- lensboard carrier, min 40% infill, support for overhang angles over 60 degrees, support touching the build plate
- lensboard lower clamp, 100% infill, no supports
- lensboard upper clamp, 100% infill, no supports
- ground glass frame, infill 30%, no supports,
- ground glass clamps, 100% infill, no supports
- tripod plate, min 50% infill, no supports

non-printed parts
- bellows, for 4x5" order the bellows from standardcameras, for 5x7 or 8x10 order from eBay
- focusing rod: T6, 2 or 4mm lead, 150mm length
- T6 nut (brass) 
- flange coupler 6mm
- M5 threaded rod, 180mm
- M5x20 screw (1x)
- M5 knurled nuts (3x)
- M5x10 screws with knurled heads (2x)
- M5x12 screws with knurled heads (2x)
- M5 press-in nuts (4x)
- countersunk screws 3x12 (30x)
- countersunk screws 2x10 (6x)
- ground glass 127x101mm
- about 600mm of 1.25mm spring steel wire for the ground glass frame
- about 100mm of 0.75mm spring steel wire for the pulling lever mechanism