Orca slicer start gcode?

[Rpm49]

Hello, is it possible for someone to help me get all of your klipper goodness working in orca slicer?

I tried using someones settings from facebook and kept the start command but even when i copy paste eli's prusa slicer start gcode, all it does is go back and forth and create a line in the middle of the bed. Thank you. Its's apparently a really nice profile so :')

[bassamanator]

Check the adjust your slicer section and use the PS start gcode as is, do not modify.

[Rpm49]

What Part? Profile, Kamp, or input shaper.

I have my Sv06+'s on some hybrid of profiles from elseware but it's at a good enough state with kamp enabled.

For my Sv06 Klipper pad. I've got a profile that i started adjusting the speed and settings from the sovol slicer. getting it +- as close as I can but it can print the orca cube nicely (Just idk if its that fast yet but its looking fast)

I still am not sure how to do kamp yet, I thought I enabled the settings but I do have a print.cfg that's referencing sovols packs and His packs so today i might just make a copy and do the print.cfg as Bass's and see if that's good enought. I was worried about other settings not being used on the pad but this is so hard for being a coding noob.

[Rpm49]

I but the start gcode worked kinda but no kamp, but it didnt want to turn off so more research there.

[dasb00ter]

I'm also sv06+

1. so the start gcode put into orca slicer was the same as in Prusa Slicer?
   2)I found a few profiles in printables. I think joescalon is one.
2. I think I know where to look for the 0 to 1 setting but I'm not adverse to you telling me.
   4)I think there are other input shaping info discussions I'm using Btt pad 7 so I will look at that

Calling the print end macro as Bassamanator suggested didn't work?

[Rpm49]

I believe it was.

If it doesnt work, flip the Print_Start to Start_Print and same with the Print_End.

I lost my orca slicer settings as i tried to sync via account login so I'm re-doing it all now Ugh

M104 S0 ; Stops PS/SS from sending temp waits separately
M140 S0
M117
PRINT_START BED=[first_layer_bed_temperature] HOTEND=[first_layer_temperature[initial_extruder]]
PURGE_LINE

;; If you are passing variables to PRINT_START, comment out above line and uncomment the last 3 lines instead. (I already did this)
;; Guide: https://github.com/AndrewEllis93/Print-Tuning-Guide/blob/main/articles/passing_slicer_variables.md
;; Make sure the variable names match (for example if you use "EXTRUDER" instead of "HOTEND")

[klb331]

THANKS! This is just what I needed.

I also added BED_MESH_PROFILE LOAD=default to make sure it loaded the bed mesh profile every time .