Grove Basic Kit for Raspberry Pi Pico | Seeed Studio Wiki

[giscus[bot]]

Grove Basic Kit for Raspberry Pi Pico | Seeed Studio Wiki

Grove Shield / Grove Starter Kit for Raspberry Pi Pico

https://wiki.seeedstudio.com/Grove-Starter-Kit-for-Raspberry-Pi-Pico/

[BGilmore21]

This demo assumes that Micropython firmware is already installed on Raspberry Pi Pico. Instructions for installing this firmware are at https://projects.raspberrypi.org/en/projects/getting-started-with-the-pico/3

[BGilmore21]

The link to lcd1602.py is dead. There is a simple micropython driver for the LCD display at github user Bhavithiran97's page, but using it requires recoding the demo.

[paul0307]

Project 4: Flashing Colors - First of all sorry for being new to all this but I get the errors below after copying and paste the code for Flashing Colors any help please as I'm still learning :-)

%Run -c $EDITOR_CONTENT

MPY: soft reboot
Traceback (most recent call last):
File "", line 15, in
File "ws2812.py", line 45, in init
AttributeError: type object 'SPI' has no attribute 'MASTER'

[limengdu]

Hello, we are concerned about the problem you mentioned with this wiki, next we will need a little time to test the code of this programme and get back to you, please wait. @Carla-Guo Please help test the programme.

[Carla-Guo]

Project 4: Flashing Colors - First of all sorry for being new to all this but I get the errors below after copying and paste the code for Flashing Colors any help please as I'm still learning :-)

%Run -c $EDITOR_CONTENT

MPY: soft reboot Traceback (most recent call last): File "", line 15, in File "ws2812.py", line 45, in init AttributeError: type object 'SPI' has no attribute 'MASTER'

@paul0307
Hi~ I just tested the demo on my side, and it works well. 👌
Could you double-check if you’ve downloaded correct ws2812.py files?
The link is here: https://files.seeedstudio.com/wiki/Grove-Temperature-Humidity-Sensor/ws2812.py 👈
And if possible, could you also share the steps you took so I can try to reproduce it exactly?

[paul0307]

Hi, I nuked my Pico and downloaded the file again, Also copied and pasted the code from the WIKI and it worked. Now I know I’m new to this but I’m sure I did it correct the first time so I’m not sure what is going on. Thanks for your time in looking into this for me now onto the next part of the kit :-) Kind Regards Paul

…

On 20 Jan 2025, at 07:40, Citric Li ***@***.***> wrote: Hello, we are concerned about the problem you mentioned with this wiki, next we will need a little time to test the code of this programme and get back to you, please wait. @Carla-Guo <https://github.com/Carla-Guo> Please help test the programme. — Reply to this email directly, view it on GitHub <#1642 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BIOGYGORKMA5ZY6BPTEINTT2LSR7ZAVCNFSM6AAAAABNTDFPPOVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTCOBYG4ZDINY>. You are receiving this because you commented.