screw tilt adjust on display obstructed

[chuckkay]

the retry button obscures the values and ccw cw on the 2 middle screw measurements... on right can't tell if it says ccw or cw, on the left i cant see the last digit, also back left and back middle says center, also bed starts to cool down between tries, so you gotta wait for it to heat up in between adjustments... should stay hot for at least 3 minutes between tries, also message at bottom says probing screws (0/4) i think it should say (0/14) = 2 taps for each spot (total spots 7) count starts at (0/4) ends with (14/4) should be (14/14)..... no clue what red and green numbers mean certainly not a consistent representation of cw and ccw

[phillipthelen]

In newer versions of the macro we disabled bed heating for this. It’s not necessary and makes it easier to run the screw adjustment.
Green means the screw is in the acceptable/good range. They don’t all need to be at exactly 0 according to Klipper docs. Below 5 “minutes”, they are already good enough.

the other things are bugs I’ll look into

[clmcgrath]

temporary workaround : open fluidd and run tilt adjust either from fluidd ui or from the touch screen and you will get a popup ui that gives the values